Filter
Top Products
PROGRAMMING
NOTICE: If this Security.l_ garage door opener is operated with a non-rolling code transmitter, the technical measure in
the receiver of the garage door opener, which provides security against code-theft devices, will be circumvented. The
owner of the copyright in the garage door opener does not authorize the purchaser or supplier of the non-rolling code
transmitter to circumvent that technical measure.
Your garage door opener has already been programmed at the factory to operate with your hand-held remote control.
The door will open and close when you press the large push button.
Below are instructions for programming your opener to operate with additional Security÷ ®remote controls.
To Add or Reprogram a Hand.held Remote Control
USING THE "LEARN" BUTTON
1. Press and release the "learn" button
on the motor unit. The learn
indicator light will glow steadily for
30 seconds.
2. Within 30 seconds, press and hold
the button on the hand-held remote*
that you wish to operate your
garage door.
3. Release the button when the motor
unit lights blink. It has learned the
code. If light bulbs are not installed,
two clicks will be heard.
To Erase All Codes From Motor Unit
Memory
To deactivate any unwanted remote, first _-_-L___®3__i
erase all codes:
Press and hold the "learn" button on motor
unit until the learn indicator light goes out
(approximately 6 seconds). All previous
codes are now erased. Reprogram each remote or keyless
entry you wish to use.
*3-Function Remotes
If provided with your garage door opener, the large button
is factory programmed to operate it. Additional buttons on
any Security÷ ®3-Function
remote or compact remote _ ._-'-_'_'_'_'_'_'_
can be programmed to
operate other Security÷ ®
garage door openers.
35