ONE-PIECEDOORS
Please read and comply with the warnings and
reinforcement instructions on the previous page. They
apply to one-piece doors also.
• Center the door bracket on the top of the door, in line
with the header bracket as shown. Mark either the left
and right, or the top and bottom holes.
• Drill 5/16" pilot holes and fasten the bracket with
hardware supplied.
If the door has no exposed framing, drill 3/16" pilot holes
and fasten the bracket with 5/16"x1-1/2" lag screws (not
provided) to the top of the door.
NOTE: The door bracket may be installed on the top edge
of the door if required for your installation, (Refer to the
dotted line optional placement drawing.) Drill 3/16" pilot
holes and substitute 5/16"x1-1/2" lag screws (not
provided) to fasten the bracket to the door,
HARDWARE SHOWN ACTUAL SIZE
© ©
Nut 5/16"-18 LockWasher 5/16"
Carriage Bolt
5/16"-18x2-1/2"
Header Wall
2x4
Header
Bracket
Optional
Placement
of Door
Bracket
Door
Bracket
Vertical
of Garage
Door
Horizontal and vertical
reinforcement {s needed for
lightweight garage doors
(fiberglass, aluminum, steeU,
door with glass panel, etc.).
(Not Provided)
8J16.48"$
Door
Bracket
For a door with no exposed framing,
or for the optional installation, use
5/16"xl-1/2" lag screws (Not Provided)
to fasten door bracket,
®
LockWasher
' 5/16"
Top of Door
(Inside Garac
Top Edge
of Door
Optional
Placement
Carriage Bolt
5/16"-18x2-1/2"
24