Sears 139.53627SRT Garage Door Opener User Manual


 
Operation of Your Opener
Activate the opener with any of the following
devices:
1. The 3-Function Remote control. Hold large push
button down until the door starts to move.
2. The Wall Control. Hold push bar down until the
door starts to move.
3. The Key Switch or Keyless Entry.
When the Opener is Activated:
1. tf open, the door will close. If closed, it will open.
2. If closing, the door will reverse.
3. If opening, the door will stop (allowing space for
entry and exit of pets and for fresh air).
4. If the door has been stopped in a partially open
position, it will close.
5. If obstructed while closing, the door will reverse.
6. If obstructed while opening, the door will stop.
7. The garage door will reverse in the closing cycle
when the invisible beam is broken. If fully open, the
door will not close when the beam is broken. The
sensor has no effect in the opening cycle.
If the sensor is not installed, or not aligned correctly,
the door can't close from any portable remote control.
It can be closed with the Wall Control, the Key
Switch, or the Keyless Entry, however, by pressing
and holding the push bar until down travel is
complete. If you release the push bar too soon, the
door will reverse.
The opener lights will blink for 5 seconds when the
safety reversing sensor causes the door to reverse.
Opener Lights will turn on under the following
conditions: When the opener is initially plugged in;
when the power is interrupted; when the opener is
activated. They will turn off automatically after 4-1/2
minutes or provide constant light when the Light
feature is activated. Bulb size is 75 watts maximum.
Weak or broken springs could allow an open
door to fall (either rapidly or unexpectedly),
resulting in serious injury, death or property
damage. If possible, use the emergency
release rope and handle only when the door is
fully closed.
ease Arm
Emergency
ReIease Handte
(Pull Down)
Manual disconnect
position
To open the door
manually:
The door should be
fully closed if possible.
Pull down on the red
emergency release
handle and lift the door
manually. To
reconnect the door to
the opener, press the
Wall Control push bar.
The lockout feature __
prevents the trolley from I"- '"'1F_-_7"-- Tro_Fe
reconnecting automatically. __ y
Iease Arm
Pull the emergency handle /-
down and back (toward the Tro;ley _ _
opener). The door can then
be raised and lowered
manually as often as
necessary. To disengage
the Lockout Feature, pull
the emergency handle
straight down. The trolley
will reconnect on the next
UP or Down operation.
Emergency
ReIease Handte
(Pall Down & Back
Towards Opener)
Lockout position
Operation of the Deluxe Lighted Console Wall Control
Lighted Push Bar
Press to open or close the door.
Press again to reverse the door during the closing
cycle or to stop the door while it's opening.
Light Feature
Press the Light button. If the opener lights are off,
they will turn on.
If the opener lights are on, (even in the 4-1/2 minute
automatic cycle) they will turn off.
But if you use the Light button to turn the lights on
and then activate the opener, the lights will turn off
after 4-1/2 minutes.
The Light button will not control the opener lights
when the door is in motion.
Lock Feature
The Lock feature is designed to prevent operation of
the door from portable remote controls. However, the
door will open and closefrom the Wall Control push
bar, the Key Switch and the Multi-Function Keyless
Entry.
To Activate:
Press and hold the Lock button for 2 seconds. The
push bar light will flash as long as the Lock feature
is on.
To turn off:
Press and hold the Lock button again for
2 seconds.The push bar light will stop flashing.
Normal operation will resume. The Lock feature will
also turn off whenever the "SRT" button on the
opener end panel is activated.
32