Filter
Top Products
13 Remove water distributors from ice machine.
Inspect each distributor for restricted orifice
holes. Be sure all holes are full open.
14 Locate ice thickness sensor. Squeeze
mounting legs together to release sensor.
Wash the metal surfaces of the sensor and the
adjustment screw with ice machine cleaner
solution. Also wash the water distributor and
curtain with the ice machine cleaner solution.
15 Locate water level sensor. Squeeze catches
together and pull up to remove sensor. Wash
metal surfaces of sensor with ice machine
cleaner solution.
16 Mix a solution of locally approved sanitizer.
Note; A possible sanitizing solution may be made
by mixing 1 ounce of liquid household bleach with 2
gallons of warm (95-115
o
F.) potable water.
17 Thoroughly wash all surfaces of the ice
thickness sensor, water level sensor, curtain
and water distributor with the sanitizer solution.
18 Thoroughly wash all interior surfaces of the
freezing compartment, including evaporator
frames, back wall, evaporator cover and the
part of the top panel covering the freezing
compartment with the sanitizer solution.
19 Return water level sensor, ice thickness
sensor, water distributors and curtains to their
normal positions.
20 Push and hold the clean button to drain the
reservoir. Push and release the clean button
again and when the flush valve indicator light
goes out, immediately pour the remaining
cleaning solution into the reservoir.
21 Circulate the sanitizer solution for 10 minutes,
then push and release the Clean button.
22 Allow the water system to be flushed of
sanitizer for at least 20 minutes, then push and
release the Off button.
23 Return the evaporator cover and front panel to
their normal position and secure with the
original fasteners.
24 Push and release the On button to resume ice
making.
Ice Storage Bin
Remove and discard all ice.
Mix a solution of Scotsman Nickel Safe ice
machine cleaner and wash all interior surfaces of
the ice storage bin to remove any mineral scale
build up. Pour excess cleaner solution into the bin’s
drain.
Mix a solution of sanitizer and thoroughly wash all
interior surfaces of the ice storage bin. Pour excess
sanitizer solution into the bin’s drain.
November 2006
Page 21
C1448, C1848, C2148W
Air and Water Cooled User Manual
Remove Water Distributors
Squeeze Tabs Together, Slide Out Until it Stops,
Then Lift to Remove
Inspect Orifice Holes
Inspect Water Distributor