Filter
Top Products
Drains
All models require drain tubing to be attached to
them. Air cooled models have a single ¾” FPT
drain fitting in the back of the cabinet. Water cooled
models have the same fitting plus an additional ½”
FPT drain fitting in the back of the cabinet.
Install new tubing when replacing a prior ice
machine, as the tubing will have been sized for the
old model and might not be correct for this one.
1 Connect water supply to water inlet fittings.
Note: This NSF listed model has a 1" anti-back flow
air gap between the end of the water inlet tube and
the highest possible reservoir water level, no back
flow device is required for the potable water inlet.
2 Connect drain tubing to drain fittings.
3 Route the drain tubing to building drain. Follow
local codes for air gap.
Use rigid drain tubes and then route them
separately – do not Tee into the bin’s drain or, if
water cooled, Tee the condenser drain into the
reservoir or bin drain.
Vent the reservoir drain. A vertical vent at the back
of the drain, extended about 8 – 10” will allow the
gravity drain to empty and also keep any surges
during draining from discharging water.
Horizontal runs of drain tubing need a ¼” per fall
per foot of run for proper draining.
Follow all applicable codes.
November 2006
Page 11
C1448, C1848, C2148W
Air and Water Cooled User Manual
Water Supply and Drain Connections
Optional
Water Filters
Water Cooled
Condenser
Inlet
Water Cooled
Condenser
Drain
Water Inlet
Connection
Potable Water
Supply
Reservoir
Drain
Floor Drain