Filter
Top Products
Water flush setting
The water flush is factory set to the automatic
position, suitable for most water conditions. The
setting can be changed to one of 5 manual settings
or left on automatic.
Flush
setting
1-
Minimum
2-
Moderate
3-
Standard
4 - Heavy
5-
Maximum
A - Automatic
Water
Type
RO water
or
equivalent
Factory
Setting for
typical
water
High TDS
water
Any with
conductivity not
less than 10
microSiemens/cm
To set:
1 Switch the machine OFF by holding the Off
button in until a number or the letter A shows
on the display.
2 Press and release the On button repeatedly
until the number on the display corresponds to
the desired setting.
3 Press and release the Off switch again to
return to the normal control state.
November 2006
Page 16
C1448, C1848, C2148W
Air and Water Cooled User Manual
Power
Status
Water
OffDe-Scale
On