Filter
Top Products
13
The unit can be operated using either the wireless remote or the front control panel.
1. Press the POWER button. This starts the unit and turns on the LED display. The soft blue
backlight will turn off after approximately 20 seconds.
2. Press the MODE button successively to select your desired mode; MANUAL, AUTO, 2
HOURS, 4 HOURS
(see Advanced Functions). Note: Ozone setting will operate for 2
hours and then revert to ANION.
3. Press the FUNCTION button successively to select ANION or OZONE. If the unit is set to
OZONE, it will convert automatically to ANION after 2 hours. However, if set to AUTO mode;
the Ozone will operate for 20 minutes, turn off for 40 minutes, and then continue to repeat the
same cycle until you stop the
AUTO mode.
4. Press the
UV/Ti02 button to power the UV Bulb sterilizer ON and OFF. We recommend you
leave this feature turned on.
Note: Do not look directly at the UV Bulb while it is operating.
5. Press the FAN button successively to adjust the fan speed between low, medium and high.
Mode
Function
Infrared
Receiver
Power Switch
Fan Speed
UV/TIO
2
LCD
Screen
GENERAL OPERATION
FUNCTION OVERVIEW
Front
Panel
Fan
Exhaust
Pre-filter
Panel
I-4506 BR7580R-1 6/25/07 7:57 AM Page 13