Filter
Top Products
TROUBLESHOOTING
If there is a problem with the vacuum cleaner, carry out the following checks
to find the cause. If the problem still persists after the checks have been made,
do not use the vacuum cleaner to prevent the possibility of an accident occurring.
Turn the ON/OFF switch to the "OFF" position, disconnect the power cord from the
wall outlet, and contact the place of purchase or your nearest Sanyo Service
Center.
Problem Cause R emedy
Suction force is weak.
The noise is loud.
The agitator does not
operate.
The dust compartment is full.
The suction hose is blocked.
The nozzle head is blocked.
The filters (main filter, pre-
filter and the secondary
filters) are dirty.
The agitator is dirty.
The motor does not operate
when the ON/OFF switch is
set to the "ON" position.
The power cord plug is not
securely inserted into the
wall outlet.
Insert the power cord plug
securely into the wall
outlet.(refer to page 5 )
Empty the dust compartment.
(refer to page 9)
Remove the blockage.
(refer to page 11)
Clean the filters.
(refer to page 10)
Remove the blockage
(refer to page 11)
Clean the agitator.
(refer to page 11 )
15
The flat belt is worn or
broken.
The agitator is worn or
broken.
Replace the flat belt.
(refer to page 12 )
Replace the agitator.
(refer to page 13 )
SANYO Electric Co., Ltd.
OSAKA, JAPAN
9BF-D-P111-00610 0204-
E
0
Part Name & lllustration
REPLACEMENT PARTS
Be sure to use only Sanyo specified parts.
Replacement parts can be obtained from your nearest Sanyo dealer
or from nearest sanyo service center.
If you want to replace any parts, do please contact the place of purchase
or your nearest sanyo service center.
Flat Belt
SC-BL3
Agitator Assembly
6630054550
This replacement can be obtained
from nearest sanyo service center.