Filter
Top Products
Contents
Page
IMPORTANT!
Please Read Before Starting .................................. 2
1. GENERAL .......................................................... 3
1-1. Tools Required for Installation (not supplied)
1-2. Accessories Supplied with Unit
1-3. Optional Copper Tubing Kit
1-4. Type of Copper Tube and Insulation Material
1-5. Additional Materials Required for Installation
2. INSTALLATION SITE SELECTION ................... 4
2-1. Indoor Unit
2-2. Connecting Indoor Units
2-3. Outdoor Unit
2-4. Outer Dimensions of Outdoor Unit
2-5. Diagram of Outdoor Unit Installation
3. INSTALLATION PROCESS ............................... 8
3-1. Embedding the Tubing and Wiring
3-2. Drain Cap and Drain Elbow
3-3. Use of the Flaring Method
3-4. Flaring Procedure with a Flare Tool
3-5. Caution Before Connecting Tubes Tightly
3-6. Tubing Connections
3-7. Insulation of Refrigerant Tubing
3-8. Taping the Tubes
3-9. Finishing the Installation
4. AIR PURGING................................................... 11
■ Air Purging with a Vacuum Pump (for Test Run)
■ Pump Down
5. WIRING INSTRUCTIONS ................................ 14
5-1. General Precautions on Wiring
5-2. Recommended Wire Length and Diameter
5-3. Wiring System Diagram
5-4. How to Connect Wiring to the Terminal
5-5. Wiring Instructions for the Outdoor Unit
6. TEST RUN......................................................... 18
7. CONNECTING A HOME AUTOMATION
DEVICE ............................................................. 19
8. INSTALLATION CHECK SHEET ...................... 19
9. ELECTRIC WIRING DIAGRAM ........................ 19
INSTALLATION INSTRUCTIONS
Model Combinations
Combine indoor and outdoor units only as listed
below.
Indoor Unit Outdoor Unit
SAP-KMRV74EH SAP-CMRV1426EH
SAP-KMRV94EH
SAP-KMRV124EH
SAP-KMRV76EH
SAP-KMRV96EH
SAP-KMRV126EH
SAP-KRV96EHDS
SAP-KRV126EHDS
Combine indoor and outdoor units only as listed in
the combination tables for 2-room outdoor unit as
shown in its respective manual.
Power Source:
50 Hz, single-phase, 220 – 240 VAC
– Inverter Multi Split System Air Conditioner –
COOL/DRY/HEAT Model
This air conditioner uses the new refrigerant R410A.
Be sure to read the yellow instruction sheet
attached to the outdoor unit for models using the
new refrigerant R410A.
The illustrations are based on the typical appearance of
a standard model. Consequently, the shape may differ
from that of the air conditioner that you are installing.
NOTE
Indoor unit A
Indoor unit B
Outdoor unit
Combination example
For Outdoor Unit
85264190456001 © SANYO 2008 SANYO Electric Co., Ltd.
Osaka, Japan
Español
Français
Deutsch Italiano
Português
EEÏÏÏÏËËÓÓÈÈÎο¿
English
08-245 CMRV1426EH_OU EN 9/22/08 10:35 AM Page a