Filter
Top Products
6. When setting the program operation erroneously
If the ERROR indicator blinks while you are setting program operation, take the following steps to
correct times you set.
1 While the blinks, the ON-time of the program operation that is incorrectly set also blinks.
2 Press the SET button to make the time to be corrected blink.
3 Correct the time using the HH or/and MM button.
4 Press the SET button. If the corrected time is acceptable, the turns off.
5 Press the PROGRAM button to complete the correction.
Programming shown below will cause ERROR setting.
(1) Programmed operation periods overlap between programs.
Example: ON-time OFF-time
(2) The OFF-time is earlier than the ON-time.
Example: ON-time OFF-time
(3) The OFF-time and ON-time is the same.
Example: ON-time OFF-time
(4) Only the ON-time or OFF-time is programmed.
Example: ON-time OFF-time
(not programmed)
The following examples will not cause ERROR setting.
(1) The OFF-time is the same with the ON-time of the subsequent operation period.
Example: ON-time OFF-time
(2) The programmed period is earlier than the preceding period.
Example: ON-time OFF-time
By pressing the PROGRAM button, programs are arranged in order of time.
Example: ON-time OFF-time
(3) Both the ON-time and OFF-time are 0:00.
Example: ON-time OFF-time
NOTE
OI-432-03 - 10EG
3 - 10
0:00
ON OFF
ON OFF
23:59
* This program is for 24-hour
continuous operation.
0:00
ONOFF
23:59
0:00
ON/OFF
23:59
0:00
ON
23:59
0:00
ON OFF
ON OFF
23:59
0:00
ON
OFF
ON OFF
23:59
3
3 TM-SH80UG 5/2/01 3:21 PM Page 10