Filter
Top Products
E-7
Sensor Sensitivity
Adjustment Slide Tab
Release Button
Release Button
Front Cover
q
q
w
e
Unit Installation
Adjusting the Sensitivity of the Odor Sensor
Unit Installation
1
1
2
2
Caution
Note:
¡Do not set in a location where the air inlet or outlet may be covered.
¡Ensure that AV equipment, i.e. TV and radios, is located at least 6.5ft away (noise may interfere
with the equipment).
¡Unplug the unit when moving or not using for extended periods and dispose of the water in
the electrolyzed water unit and tank (water may spill or mold and bacteria may develop).
¡Do not tilt the unit when in use. The electrolyzed water unit may cease to operate properly
or water may spill.
Adjust the sensor sensitivity
adjustment slide tab.
¡The tab is set to the middle when shipping.
Set the tab to this location during normal
operation.
¡To operate when even slightly dirty
set to “High”
¡To operate infrequently
set to “Low”
Place the unit on a stable and horizontal surface
and in a location where the air circulates well
around the room.
¡This unit operates more effectively when the unit is set in the
middle of a wall facing the center of the room.
Ventilate the room to clean the air before plugging the cord into the wall outlet.
¡When the power plug is inserted into the wall outlet and the unit starts operating, the sensor will detect
the cleanliness of the air and use this as a reference for making settings. The automatic operation lamp
(green) will flash for a short while (about 3 minutes) while this is being done. If the air quality is detected
as being clean, the settings will be updated automatically to reflect this.
q Press the Release buttons (both
sides) at the bottom of the unit, w pull
the front cover away from the unit, and
e lift.
ABC-VW24A_GB_US.qxd 09.10.1 4:52 PM ページ7