Filter
Top Products
A
4
Assemble Upper Handle
Push upper handle onto lower handle. Make sure grip curves
away from cleaner. Align the holes on the upper handle
to the holes on the lower handle. Insert a 2-part bolt (A)
in center of the handle and tighten.
Attach Lower Handle
Raise the dust cup support. Push the lower handle (largest
end down) through the tube of the dust cup support and into
the handle socket at the back of the cleaner. Align the holes,
insert a 2-part bolt (A), and tighten.
Dust Cup
Support
Tube
Lower
Handle
Handle
Socket
A
Secure Cord Clamp
Secure the electrical cord to the dust cup support with the
cord clamp and screw (C). Place the cord clamp over the
electrical cord. Screw the clamp to the tab below the right
latch; start the screw by hand, then tighten.
Extension Cord
To install or change the extension cord, slip cord lock over one
of the cords ends. Plug the pigtail into the extension cord. Clip
both ends of the cord hook behind the plug ends to make a
secure connection.
The cleaner has a convenient cord storage hook attached to
the handle. However, some models feature a quick release
cord hook on the upper handle. A downward twist of the cord
hook frees the cord for quick removal. With either style, wind
the cord around the hooks for storage. Fasten the plug to the
cord to prevent unwinding.
Hook Bag Top
Slip the ring at the top of the cloth bag over the bag support
hook on the back of the cord hook.
A
A
U
ppe
r
H
andle
Lowe
r
H
andle
H
andle
S
ocke
t
C
NOTE: Make sure cord from upper handle to cleaner
runs along side of tubes and not wrapped around
tubes.