Filter
Top Products
Cooling Your Room
To adjust the temperature, press the Temperature buttons on the remote
control or unit one or more times until the desired temperature is displayed.
The temperature can be set between 64°F and 86°F.
Result
:
◆
Each time you press the temperature buttons:
– The temperature is adjusted by 1°F and displayed on
the control panel
– The unit beeps
◆
The air conditioner starts cooling if the room temperature is
higher than the selected temperature.
3
Press the (On/Off) button.
Result:
◆ The air conditioner starts up in the mode selected when the
unit was last used.
◆ The unit beeps twice.
☛
The air conditioner is fitted with a protection mechanism to prevent
the unit from being damaged when it is started immediately after
being:
◆ Plugged in
◆ Stopped
It will start up normally after three minutes.
If the COOL indicator is not lit on the unit:
◆
Press the COOL button on the remote control
or
◆
Press the Mode button on the unit one or more times until the COOL
indicator lights up
Result
:
◆
The unit beeps each time you press the COOL/Mode button.
◆
The air conditioner starts up in the Cool mode.
➢
You can change modes at any time.
You must select the Cool mode if you wish to lower the temperature
in your room. You can also set the fan speed.
1
2
To set the fan speed:
◆
Press the HIGH, MED or LOW button on the remote control as desired.
or
◆
Press the Fan Speed button on the unit one or more times until the
desired Fan speed indicator lights up.
4
To control the direction of the air flow, refer to page 10.
5
Remote Control
Control Panel
E-8