Filter
Top Products
Solving Common Problems
Technical Specifications
Explanation / Solution
◆ Check that the circuit breaker used for the air conditioner has not been
triggered.
◆ Check that the power cable is plugged into a wall socket and the socket is
switched on, if necessary.
◆ Check that the temperature indicator on the unit is lit; if necessary,
press (On/Off) on the remote control or unit.
◆ Check that there are no obstacles between you and the unit.
◆ Replace the remote control batteries if necessary.
◆ Check that you are close enough to the unit (seven metres/yards or less).
◆
Ventilate the room.
Problem
The air conditioner does
not
operate at all
The air conditioner does not
operate with the remote
control
Odors are permeating the
room during air conditioning
◆ Check that you are pointing the remote control at the remote control sensor
on the unit.
◆ Replace the remote control batteries if necessary.
No beep is heard when you
press (On/Off) on the
remote control
◆ Check that the correct operating mode has been selected(COOL).
◆ The room temperature may be too low.
◆ Dust may be blocking the air filter; refer to page 14 for cleaning instructions.
◆ Check that there is no obstacle blocking the air flow into or out of the unit.
The air conditioner does not
cool
◆ Check that the air conditioner has been switched on; if necessary, press
(On/Off) on the remote control or unit.
◆
The blades may not move when the air conditioner runs in the Energy Saving mode.
The air flow direction does
not change when you press
the Swing button
◆ Check that the timer has been programmed correctly; refer to page 11~13.
The timer is not correctly
triggered
Before contacting an authorized service center, perform the following simple checks.
They may save you the time and expense of an unnecessary call.
E-17
Model
Power Supply
AW069AB
AW078AA
AW088AA
AW089AB
AW108AA
AW109AB
AW128AA
AW129AB
AW1480A
AW1880A
AW2480C
AW2490D
230 - 208V~, 60Hz
Design and specifications are subject to change without notice.
115V~, 60Hz