Filter
Top Products
Cooling Your Room
You must select the COOL mode if you wish to adjust the :
◆ Cooling temperature
◆ Fan speed when cooling
1
If necessary, press (ON/OFF) button.
Result:
◆ The On/Off indicator on the wired remote controller comes on.
◆ The air conditioner runs in the mode selected when
◆ the unit was last used.
The air conditioner is fitted with a protection mechanism to
prevent the unit from being damaged when it is started
immediately after being:
◆ Plugged in
◆ Stopped
lt will start up normally after three minutes.
IMPORTANT
To select the COOLmode, press the Mode button until is displayed at
the top of the wired remote controller.
Result:
◆ The air conditioner runs in COOL mode.
2
You can change modes at any time.
NN
NN
oo
oo
tt
tt
ee
ee
To adjust the temperature, press the Temperature buttons one or more times
until the required temperature is displayed. Possible temperatures are between
65
O
F and 86
O
F inclusive.
Result:
◆ Each time you press Temperature buttons:
- The temperature is adjusted by 1
O
F.
◆ The air conditioner starts cooling, provided that the room
◆ temperature is higher than the selected temperature ; the fan
◆ will, however, operate.
3
Select the fan speed by pressing the Fan button one or more times until
the intended value is displayed :
Automatic(rotated : ➔➔)
Low
Medium
High
4
To control the direction of the air flow, refer to page 17.
5
E-
14