Filter
Top Products
Operating Your Air
Conditioner
To obtain the best possible results from your air conditioner, it is important that you operate it
properly. This section tells you how to set the controls and how to direct the cooled air.
Starting your air conditioner
Fire Hazard
-Do not use an extension cord.
Doing so can result in death, fire, or
electrical shock.
1. Set the System Control to the
desired setting.
LO COOL - for sleeping comfort
MED COOL - for normal cooling
HI COOL - for maximum cooling
FAN ONLY-to circulate room air without
cooling it
2. Turn the Thermostat Control to number
6 (mid setting). You can adjust the air
conditioner’s cooling performance by
setting the Thermostat Control to a higher
number for more cooling or to a lower
number for less cooling. Experiment to
find the setting(s) that suits you best.
IMPORTANT: If you turn the air conditioner
off, or if the compressor turns off when you
lower the Thermostat Control, wait at least
three minutes before turning the air condi-
tioner back on. If you don’t wait, you may
blow a fuse or trip a circuit breaker.
Electrical Shock Hazard
Plug into a grounded 3-prong outlet.
Do not remove ground prong.
Failure to follow these instructions
can result in death or electrical shock.
continued on next page
5