Roper Air Conditioner Air Conditioner User Manual


 
Troubleshooting
Listed in the chart below are the most common problems consumers run into with their air
conditioners. Please read through this chart before calling for service. It could save you the
cost of a service call.
PROBLEM
Air conditioner
won’t run
CHECK THE FOLLOWING
Is the unit plugged into a live circuit with proper voltage?
Has the time-delay fuse blown or circuit breaker tripped?
Is the System Control set to UNIT OFF?
Is the Thermostat Control set correctly?
Has the local power failed?
Unit blows
fuses or trips
circuit breaker
Are time-delay fuses being used?
Is an extension cord being used? Do not use an extension cord
with this or any other appliance.
Are you waiting three minutes before trying to restart the unit?
Unit turns on
and off
OR
does not cool
the room
Is the air filter clean?
Are the coils clean (both inside evaporator and outside
condenser)?
Is there excessive moisture or heat in the room (open
container cooking, showers, etc.)?
Is the System Control set too low?
Is the Thermostat Control set too low?
Normal operating sounds
When your air conditioner operates
normally, you will hear sounds such as:
l Pinging or clicking as water droplets hit
the condenser. Water droplets help cool
the condenser.
l Air movement from the fan, especially on
HI COOL setting.
l Clicks from the cooling cycle.
Sounds may also be caused by house
construction - such as vibration of the unit
due to wall construction or an unsteady
window mounting area.
10
WITH QUESTIONS OR COMMENTS