Roper 288 Stove User Manual


 
REMOVABLE OVEN RACKS AND
GUIDES
Be careful not to scratch the oven finish when installing
or removlng oven racks.
To Install:
1.
Put the pegs on the end of the rack guide into the holes
in the oven back.
2.
Lock the front hook in the slot in the oven side.
3.
Set the raised back edge of the oven racks on a pair
of rack guides so the hooks at the sides of the rack run
underneath the rack guides.
4.
Push the rack in until you reach the bump in the rack,
then lift the front of the rack a bit and push the rack all
the way in.
To
remove:
1.
Pull the oven rack out, then up.
2. Lift thefrontoftherackguidetounhookitfromtheoven
wall and pull out.
REMOVABLE OVEN AND BROILER
/
I
RACK HOOK
RACK
BUMP
II II
II
1.
2.
3.
Open the door fully and raise the release tab on each
door hinge (see fig. A).
Raise the release tabs as far as they will go (see fig. B),
then close the door to the point where it will hold a
partially open position.
Grasp the door firmly at the sides, pull the lower edge
away from the oven and lift the door off the hinge arms
(see fig. C).
To
replace:
1.
Slip the hinge arms into the upper portion of the slots in
the door.
2.
Lower the door to the fully open position and push the
release tabs down (see fig. A).
DOORS
Remove the doors for easier cleaning.
To remove:
Fig. A
‘/ II
Fig. B
\
‘\
‘.
II
~~
._
REMOVABLE OVEN BOTTOM
Remove the oven bottom for easier cleaning.
Be careful not to scratch the oven finish when removing or
installing oven bottom.
To remove:
1.
Remove the oven racks and guides (see above).
2. Lift the front of the oven bottom enough to clear the
front frame, then pull out.
To replace:
1. Slide the oven bottom into the oven so that the back
edge of the oven bottom rests on the ridge in the back
oven wall.
2. Lower the front of the oven bottom inlo place behind the
front frame.
17
FRONT FRAME
GMNT18