Filter
Top Products
33
Appendices
Can’t perform format conversion
Is a format supported by the VC-30HD being input?
The VC-30HD does not support up/down scalling, interlace/progressive (I/P) conversion,
or frame rate conversion. The [OUTPUT FORMAT] indicators flash when the input and
output formats are not compatible. No output is possible while the [OUTPUT FORMAT]
indicators are flashing. For information on formats that can be input and output, refer to
“Supported Formats” (p. 10).
The audio level is too high/too low
Does the signal level from the source equipment match the input signal level on the
VC-30HD?
The RCA connectors on the front panel and the XLR connectors on the rear panel have
different nominal input signal levels. Connect source equipment that is capable of
output at the levels shown below.
• RCA (front panel) -20 - 6 dBu
• XLR (rear panel) -8 - +10 dBu
Also, when connection cables containing resistors are used, the signal level from the
source equipment is lowered. Use a connection cable that does not contain a resistor.
Cannot input from an i.LINK device
Has communication been established between the VC-30HD and the i.LINK source
device?
Input from i.LINK equipment is not possible unless communication has been
established. If the [i.LINK] indicator in [VIDEO INPUT] section is flashing, communication
has not been established. Wait until the indicator lights up steadily, then perform
output.
HDMI audio is not converted
Is the [HDMI + AUDIO] [VIDEO INPUT] indicator illuminated?
HDMI audio input is canceled when this indicator is illuminated. When you want to
convert HDMI audio, select [HDMI].
Troubleshooting