Filter
Top Products
13
Turning the Power On and Off
The power to the VC-30HD is switched off automatically when four hours have elapsed
with no input of video or audio signals (factory default). When this happens, the VC-
30HD does not function even though the POWER switch is at [ON]. To turn on the power
again, first slide the POWER switch back to [OFF], then slide it to [ON] again.
Deactivating AUTO OFF
If automatic power-off is not needed, use the procedure described below to deactivate
the feature.
1. Press all buttons for 5 seconds.
Press and hold the [VIDEO INPUT], [OUTPUT FORMAT], and [AUDIO INPUT] buttons for
five seconds.
fig.all-select-buttons.eps
2. Make sure the feature has been deactivated.
When the AUTO OFF feature is deactivated, the [VIDEO INPUT] and [OUTPUT FORMAT]
indicators all flash.
fig.disable-power-off.eps
3. Enable the feature again.
In the same way as in step 1, press and hold all buttons for five seconds. When the
feature is enabled, the [AUDIO INPUT] indicators all flash.
fig.enable-power-off.eps
The buttons are nonfunctional while the indicators are flashing (approximately five seconds). Wait
for the indicators to stop flashing before attempting any operations.
About AUTO OFF