Filter
Top Products
27
RF-RBUSB
• 2 stereo HD quality + 2 stereo CD quality -or-
• 3 stereo HD quality
Note: HD streams are available if using the Rocketboost Wireless HD
Audio Starter Kit wireless sender. If your system is in a maximum audio
stream state, then the Send mode indicator will not light on the
wireless sender devices that have exceeded the maximum. To use those
device's audio streams, you need to turn off one of your other wireless
senders.
Maintaining your system
Use a soft cloth dampened with a weak solution of mild detergent and
water. Dry the device immediately afterwards with a clean cloth. Do not
use abrasive cloth, thinners, alcohol, or other chemical solvents, because
they may damage the finish or remove the panel lettering.
Cautions:
Do not block the ventilation openings.
If the power cord is damaged, it must be repaired by a qualified
technician.
Troubleshooting
Check this information for a possible solution before calling for
assistance.
General troubleshooting
• Every Rocketboost network must contain only one hub device,
which helps other Rocketboost wireless devices join the network.
• You can turn any Rocketboost wireless sender or wireless
sender/receiver into a hub by using the HUB STATUS or HUB ENABLE
switch on the back of the device. The network can only have
one hub.
• The hub device must have power for the audio network to
operate. The hub can be in standby (power-saving mode), but
must remain plugged in.
• The existing hub device will be the device with the green
power indicator.
• The unobstructed operating range of a Rocketboost network is 150
feet (45 meters).
RF-RBUSB_11-0204_MAN_V1.fm Page 27 Monday, May 2, 2011 8:04 AM