Filter
Top Products
SECTION 6: LINEAR & DOUBLE LINEAR HEATER INSTALLATION
13 of 73
SECTION 6: LINEAR & DOUBLE LINEAR HEATER INSTALLATION
The figures in this section provide a general overview of
component placement in a Linear and Double Linear
system. The location of some components such as
supports and couplings is crucial for proper installation.
Assemble the heater components as shown on Page 14,
Figure 18.
For optional reflector configurations for linear heaters see
Page 6, Figure 3 through Page 7, Figure 9. Install
appropriate suspension hardware, beam clamps, chain or
rod at predetermined locations. Adjustments of chain
length will provide uniform pitch.
If any step is unclear, please contact Roberts-Gordon
LLC at +44 (0)121 506 7700.
6.1 Linear Standard Parts List
* PVC coating must be removed prior to installation.
** If an IP55 protected fan is required, this fan replaces
07260001, 07260002, or 07260003.
*** Some models may receive S-hooks (P/N 91907302)
or spring hooks (P/N 91903300), rather than bow
shackles.
WARNING
Cut/Pinch Hazard
Wear protective gear during installation,
operation and service.
Edges are sharp.
Failure to follow these instructions can result
in injury.
Part No. Description
HE15ST
HE20ST
HE25ST
HE30ST
HE35ST
HE40ST
HE45ST
HE50ST
033XXXXX Burner Assembly (Input and Fuel Varies) 1 1 111111
07260001 Fan Package XP 1 1 1 1 1 1 - - -
07260002 Fan Package XP 2 (optional) - -------
07260003 Fan Package XP 3 - ----111
07260051 Fan Package 1 IP55 (optional)** 1 1 1 1 1 - - -
07260052 Fan Package 2 IP55 (optional)** - -------
07260053 Fan Package 3 IP55 (optional)** - ----111
03051100Burner Tube, 100 mm x 3048 mm 11111111
91409408Tube, 100 mm x 3048 mm -1122233
S5127WFan Tube, 100 mm x 3048 mm, with 3048 mm Swirler -1111111
S5134WFan Tube, 100 mm x 3048 mm, with 2134 mm Swirler 1-------
01329600Standard Coupling Assembly 12233344
01329700Coupling Lock 12233344
02750303Reflector, Aluminium, 2439 mm 34466677
027503SSReflector, Stainless Steel, 2439 mm (Optional)* 34466677
02750800Reflector End Cap, Aluminium 22222222
027508SHReflector End Cap, Stainless (Optional)* 22222222
03090100Tube and Reflector Hanger 34455566
01318901Tube Clamp Package (including Nut, Washer & Bolt) 11111111
91908004Wire Form 23355566
94320812 Screw #8 x 3/4, (Goes with 03050000) 4 6 6 10 10 10 12 12
03050000Reflector Support Strap 23355566
E0007576Bow Shackle*** 34455566
91107720 U-Clip Package (20 Pieces) 1 1 111111
S7199K Damper Flange Assembly (For use on Multiburner Systems) 1 Per Heater