Rinnai 2424WC Water Heater User Manual


 
Model 2424WC 800-621-941917
Warning: If you do not follow these instructions exactly, a fire or explosion
may result causing property damage, personal injury or loss of life.
A. This appliance is equipped with a direct igni-
tion device which automatically lights the
burner. Do not try to light the burner by hand.
B. BEFORE OPERATING: Smell all around
the appliance area for gas. Be sure to
smell below the unit because some gas is
heavier than air and will settle to the
ground.
WHAT TO DO IF YOU SMELL GAS
Do not try to light any appliance.
Do not touch any electric switch, do not
use any phone in your building.
Immediately call your gas supplier from a
neighbor’s phone. Follow the gas
supplier’s instructions.
FOR YOUR SAFETY READ BEFORE OPERATING
If you cannot reach your gas supplier, call
the fire department.
C. Use only your hand to operate remote con-
trol keypad.
Do not use tools. Force or
attempted repair may result in a fire or ex-
plosion. If the remote keypad doesn’t work,
call a qualified service technician.
D. Do not use this appliance if any part has
been under water. Immediately call a quali-
fied service technician to inspect the appli-
ance and to replace any part of the control
system and any gas control which has been
under water.
6) Wait (5) minutes to clear out any gas. If
you then smell gas, STOP! Follow “B” in
the safety information above on this label.
If you don’t smell gas, go to next step.
Closed manual valve
(“OFF” position)
Open Manual valve
(“ON” position)
1) STOP! Read the safety information above
before proceeding.
2) Set the thermostat to lowest setting.
3) Turn off all electric power to the appliance.
4) This appliance is equipped with a direct igni-
tion device which automatically lights the
burner. Do not try to light the burner by hand.
5) Turn the manual valve located at gas
inlet of the appliance clockwise
to “OFF”.
OPERATING INSTRUCTIONS