Rheem 300 series Water Heater User Manual


 
LIGHTING THE WATER HEATER
25
LIGHTING INSTRUCTIONS
Using the gas control light the water heater as follows:
1. Stop, read the safety information on page 24.
2. Turn the gas control knob fully clockwise to the “z” (off) position.
3. Wait five (5) minutes so any build up of unburnt gas can escape. If you
then smell gas, stop and follow “C” in the safety information. If you do not
smell gas, proceed to step 4.
4. Turn the knob to the “·” (pilot) position.
5. Depress the knob fully (until star disappears below housing) and after
30 seconds, whilst keeping the knob depressed, repeatedly press the
igniter button (for up to 40 seconds) until the pilot flame ignites.
Warning: Keep your face clear of the combustion chamber opening while
pressing the igniter.
Note: It is not possible to depress the knob fully if the gas control has
activated its safety shut-off feature. In this case, wait 60 seconds for the
gas control to reset.
6. Keep the knob depressed for 20 seconds after the pilot flame lights. The
pilot can be checked by looking through the opening at the top of the front
cover to view the flame in the reflector.
7. Release the knob and check the pilot is still alight.
8. If the pilot has failed to light or has not remained alight, turn the gas control
knob to the "z” (off) position. Wait five (5) minutes for any unburnt gas to
escape and then begin again at step 3.
Note: Failure to wait five (5) minutes may result in a fire or explosion.
9. When the pilot flame remains alight with the gas control knob released,
turn the knob anticlockwise to the setting of ‘6’. This will give a water
temperature of about 60°C.
10. Refer to “Temperature Adjustment” on page 4, if further temperature
adjustment is required.
The main burner will now automatically ignite when heating is required and
extinguish when the water has been heated to the set temperature. If the main
burner does not light at the selected setting, the water may already be at the
selected temperature.
Note: Never press the igniter button while the top knob is in a numbered
position.