Filter
Top Products
27
CLEANING AND MAINTENANCE
CLEANING AND MAINTENANCE
You should regularly carry out the cleaning and maintenance described in this section.
Refer to your mask manual for detailed instructions.
DAILY CLEANING
MASK
Clean the mask according to the instructions supplied with the mask.
AIR TUBING
Disconnect the air tubing from the S8 AUTOSET SPIRIT (and humidifier, if used) and hang
the tubing and mask in a clean, dry place until next use.
HUMIDIFIER
If you are using a humidifier, remove it from the S8 AUTOSET SPIRIT and clean it
according to the instructions in the humidifier user’s manual.
WEEKLY CLEANING
1. Remove the air tubing from the S8 AUTOSET SPIRIT and the mask.
2. Wash the air tubing in warm water using mild detergent. Rinse thoroughly, hang
and allow to dry.
3. Before next use, assemble the mask and headgear according to the user
instructions.
4. Reconnect the air tubing to the air outlet and mask.
PERIODIC CLEANING
1. Clean the exterior of the S8 AUTOSET SPIRIT with a damp cloth and mild liquid
soap.
2. Check the air filter for blockage or holes (see “Replacing the Air Filter” on
page 28).
!
WARNING
• Beware of electric shock. Do not immerse the unit or power cord in water.
Always unplug the unit before cleaning and be sure it is dry before plugging back
in.
• The mask system and air tubing are subject to normal wear and tear. Inspect
them regularly for damage.