Filter
Top Products
3
5
4
C
B
A
A
B
C
E
D
A
1.4 Install the presser foot lifting controller (Fig. 3)
First connect the chain B with presser foot lift lever
C by hooks A, then install the pedal assembly D on
the rung of the stand, move the controller E leftward
or rightward to make the chain in one line, fix it
with bolt and nut, finally connect the hook with the
controller E.
(An automatic presser foot lifter is also available,
please refer to parts manual Part 7. "Knee lifter and
winding components")
.
.
1.5 Install the thread stand (Fig. 4)
The thread stand should be located on the right
backside of the table. Threading should be smooth
when sewing. When the machine head is turned
backward, it should not be touched with the thread
stand, then tighten the nut A. .
1.6 Install the motor (Fig. 5)
Move the motor C leftward or rightward to make the
hand wheel belt groove A and motor pulley belt
groove B run in line. .