Filter
Top Products
TROUBLESHOOTING
PROBLEM
EXPLANATION
SOLUTION
Does
steam go
out from
the boiler?
It may happen that, while filling the
tank, some water overfills the cap
and flows inside the boiler wetting
the insulating material
In order to solve the problem, we suggest
using the machine as usual so that the
insulating material dries up in about one
hour through the heat of the machine. In
case you still have this problem after one
working hour, please contact the service
centre.
Does the
nozzle or
gun leak
water
mixed with
steam?
1) While filling the tank you may
have poured too much water into it.
1) The problem will go on until the excess
water is emptied. Keep the steam button
depressed until the water in the tank is at
the correct level.
There is
no steam
coming out
of the
nozzle or
gun?
1) The steam knob (where
supplied) might be closed
2) The foot pedal is not plugged in
(i500B)
3) The boiler switch might be off
4) The water might be used up.
1) Open the steam knob anticlockwise.
2) Plug the 4-pin receptacle into the boiler.
3) After the boiler switch comes on, wait for
10 minutes so the boiler produces steam.
4) Fill it following the instructions carefully.
Does the
steam leak
dirty
water?
Some dirty might have gone into
the tank with the water and it is
given off from the iron.
Fill the empty tank with 1 liter of water,
screw the cap up, shake it, unscrew the
cap and empty the tank. Repeat the action
until the water is cleaned. We do not
recommend the use of any additive to pour
in the tank. Before ironing again spray
some steam on a cloth until clean steam
comes out.