Filter
Top Products
Regency
®
L900E Direct Vent Gas Fireplace 39
MAINTENANCE
1) Remove the exterior brick panels.
2) Remove the glass door.
VALVE TRAY REPLACEMENT
a. Release the 2 door latches on the left
and right side at the top of the fi rebox.
b. Swing the door out from the top and release
the hinges on the left and right side of the
door by lifting them up.
Hinge
Door
Latch
Latch Location
c. Place the door on a soft surface to prevent
scratching.
3) Loosen the screw that holds the right side
heat shield in place.
4) Lift up and pull out the heat shield slightly
to clear the screwheads and then hang it
on the top bracket (located directly above
the heat shield).
8) Remove the grate by undoing the 2 screws
on the right and left side.
9) Remove the front burner by removing the
screw.
10) Remove the back burner by removing the
screw.
MAINTENANCE
Grate
Front Burner
Front Burner Removed
Back Burner
Heat
Shield
5) Disconnect both sources of power; the
power cord, located on the left hand side of
the fi rebox and the wires connected to the
back-up battery located on the right side of
the fi rebox.
Backup
Battery
6) Remove the log set.
7) Remove the interior brick panels.
Power
Receptacle