Filter
Top Products
10 F37 Regency
®
Rear Flued Room Sealed Freestanding Gas Heater
INSTALLATION
Diagram 2
HORIZONTAL INSTALLATIONS
Diagram 1
*Diagram 2: Local codes or regulations may
require different clearances.
RESIDENTIAL AND MANUFACTURED HOMES /
MOBILE HOMES INSTALLATIONS
You will require the following components with your new Regency
®
Rear Flued Room Sealed Freestanding Gas Stove. Please review your product
to make sure you have everything you need. In the event that you are missing any part, contact your dealer.
Note: These are the minimum pieces required.
Other parts may be required for your particular installation.
Minimum components for a Horizontal Installation:
946-112 Horizontal Termination Kit which includes:
1 6-5/8" dia. x 18" (168mm dia. x 457mm) Black Pipe
1 4" dia. x 18" (102mm dia. x 457mm) Aluminum Flue
1 Astro Riser Vent Terminal
1 Wall Penetration Heat Shield for Heat Sensitive walls
(Wall Thimble) (2 pcs)
1 Decorative Wall Trim (Black)
1 Tube Mill-Pac
Screws
Optional Components:
946-204 45
o
Elbow - 6-5/8" (168mm) Black pipe
and 4" (102mm) Aluminum Flue
946-205 Vinyl Siding Shield for Riser Vent
Terminal
946-208/P Flue Guard
940 Square Wall Thimble Cover*
942 Wall Penetration
Heat Shield*
* Simpson Dura-Vent components
1) Set the unit in its desired location. Check to
determine if wall studs are in the way when
the fl ueing system is attached. If this is the
case, you may want to adjust the location
of the unit.
2) Assemble the desired combination of pipe
and elbow to the appliance adapter with pipe
seams oriented down. Offset the pipe seams
as double seams in one place will cause the
outer pipe to take an oval shape. Kit comes
complete with 18" (457mm) of straight fl ue
- 6-5/8" (168mm) dia. black outer pipe and
4" (102mm) dia. inner fl ue.
3) With the pipe attached to the stove, slide
the stove into its correct location, and mark
the wall for a 9-1/2" (241mm) (inside
dimensions) round hole. The center of the
round hole should line up with the centerline
of the horizontal pipe, as shown in diagram
1. Cut and frame the 9-1/2 (241mm) round
hole in the exterior wall where the fl ue will
be terminated. If the wall being penetrated is
constructed of non-combustible material, i.e.
masonry block or concrete, a 7" (178mm)
diameter hole is acceptable.
Note:
a) The horizontal run of fl ue should have
a 1/4 inch (6mm) rise for every 1 foot
(305mm) of run towards the termination.
Never allow the fl ue to run downward.
This could cause high temperatures and
may present the possibility of a fi re.
b) The location of the horizontal fl ue ter-
mination on an exterior wall must meet
all local and national building codes,
and must not be blocked or obstructed.
See the diagram in the "External Flue
Termination Locations" section.
c) Snorkel Terminations:
For installations requiring a vertical rise
on the exterior of the building, Astro Riser
Vent Terminations as shown in Dia. 2
is available. Follow the same installa-
tion procedures as used for standard
Horizontal Termination.
NEVER install the Astro Riser vent upside
down.