Regency C34-LP2 Stove User Manual


 
8 Regency CLASSIC C34-2 Direct Vent Freestanding Gas Heater
INSTALLATION
PEDESTAL ASSEMBLY
1) For easier assembly, tip the stove on its
back (preferably onto a soft surface to
prevent scratching).
2) Unscrew the 4 bolts in the underside of the
stove. Align the holes in the corners of the
pedestal top with the corresponding holes
in the base of the stove. Use washers
which are supplied with the pedestal as
shown in diagram. Reinstall bolts.
Anchoring Brackets Hold
Down Package Part# 846-585
10)Put the insulation gasket on the back of the
fan. Line up the keyhole slots with the
matching screws and pull back slightly to
lock into place. While holding fan assembly
in place, tighten screws.
11)Remove the dummy plug from the right side
of the bottom shield or pedestal and install
the supplied fan switch.
12)Attach the hot wire from power cord to the
thermodisc.
13)Slide thermodisc under the thermodisc brack-
et.
14)Connecting wires to the 3 way switch:
a. Connect the red wire from the fan to the
top of the 3 way switch.
b. Connect black wire from fan to the bottom
of the 3 way switch.
c. Connect white jumper wire to middle of
the three way switch. See wiring dia-
gram below.
15)Connect white wire from fan motor to neu-
tral on the power cord.
16)Pull power wire back and put strain relief
grommet in place as per diagram 4.
17)Reverse steps 3-1 to complete installation.
Fan Removal
1) Disconnect the power to the fan.
2) Allow the stove to cool to room temperature.
3) Open the pedestal door and remove the
screws on the door cover plate. (Leg units:
remove the bottom access panel.)
4) Loosen the screws of the nutserts.
5) Remove the fan assembly from the key slots
at the fan base and pull fan out through the
rectangular opening. (Diagram 3).
6) Turn fan 90 degrees. (Diagram 2). (Pedestal
units only).
7) Disconnect the green ground wires to the
grounding lug.
8) Disconnect the white wire of the fan from
the power cord.
9) Disconnect the red wire and black wire
(from fan to Fan Switch).
10) Take fan out from the stove body. (Diagram
1).
LEG AND BOTTOM
SHIELD ASSEMBLY
These instructions apply to the steel leg, painted
cast leg and the gold plated cast leg. It will be
easier to attach the legs to the stove if it is tipped
on its back (preferably on a soft surface to
prevent scratching).
1) Remove the 4 bolts in the underside of the
base and discard.
2) Slide the bolt and washer (supplied with the
bottom shield) through the leg, then slide the
bottom shield in between the leg and the
base of the stove. Tighten the bolts.
3) Hook up the Burner ON/OFF switch.
4) Level the stove by adjusting the levelling
bolts in the bottom of each leg.
3) Hook up wires to Burner ON/OFF switch
and valve assembly (be careful not to pinch
wires). See diagram above.
4) Push the Regency logo into the two holes
in the front bottom left corner of the pedes-
tal cover plate.
Note: Any paint touch up should be done
prior to placing logo on pedestal.