Filter
Top Products
Part 4: Operating Instructions
NOTE: Carbon deposits maybe present on the glass and logs. This is
normal and must be cleaned when the heater is serviced or the glass door
is cleaned. Please refer to the General Glass Information section on page
15.
General Glass Information
Warning: Only glass approved for use by Raypak Australia may be
used for replacement. The use of substitute glass will void all
warranties.
Take care to avoid breaking the glass.
Warning: Under no circumstances is this appliance to be operated
without the front glass or with a broken glass. Replacement of the
glass including the gasket as supplied by Raypak Australia should
be done by a licensed and qualified service person.
Window Frame Assembly Removal
1. Shut off gas. (see lighting instructions)
2. If the unit has been operating, let it cool.
3. Open the two side doors.
4. Open the clamps on the two sides (Fig. 2)
5. Pull the frame forward.
6. To re-install window frame assembly, follow the above procedure in
reverse
Fig. 2 Window frame removal
Glass Cleaning
It is necessary to periodically clean condensation and film from the glass.
Condensation, which is normal during start up, forms on the inside of the
Page 11 of 27