Filter
Top Products
not push in or turn by hand, do not try to repair it,
call a qualified service technician. Force or at-
tempted repair may result in a fire or explosion.
D. Do not use this appliance if any part has been
under water. Immediately call a qualified service
technician to inspect the appliance and to
replace any part of the control system and any
gascontrol which has been under water.
LIGHTING INSTRUCTIONS
1. STOP! Read the safety information above.
2. Set the thermostat on the lowest setting.
3. Turn off all electric power to the appliance.
4. Remove boiler door panel.
5. Push in gas control knob slightly and turn clock-
wise to “OFF”.
NOTE: Knob cannot be turned from “PILOT” to
“OFF” unless knob is pushed in slightly. Do not
force.
6. Wait five (5) minutes to clear out any gas. Then
smell for gas, including near the floor. If you smell
gas, STOP! Follow "B" in the safety information
above on this label. If you don't smell gas, go to the
next step.
7. Locate pilot mounted on the burner drawer.
8. Turn knob on gas control counter clockwise
to “PILOT”.
PILOT
BURNER
9. Push in control knob all the way and hold in.
Immediately light the pilot with a match. con
tinue to hold the control knob in for about one (1)
minute after the pilot is lit. Release knob and it
will pop back up. Pilot should remain lit. If it
goes out, repeat steps 5 through 9.
* If knob does not pop up when released, stop
and immediately call your service technician or
gas supplier.
* If the pilot does not stay lit after several tries,
turn the gas control knob to “OFF” and call
your service technician or gas supplier.
10. Stand to the side of the boiler and turn the gas
control knob counter clockwise to “ON”.
11. Replace boiler door panel.
12. Turn on all electric power to the appliance.
13. Set the thermostat to the desired setting.
TO TURN OFF GAS TO APPLIANCE
1. Set the thermostat to the lowest setting.
2. Turn off all electric power to the appliance.
3. Remove boiler door.
4. Push in the gas control knob slightly and turn
clockwise to "OFF". Do not force.
5. Replace boiler door panel.
BOILERS WITH AUTOMATICALLY LIT IID PILOTS
AND MANUAL GAS VALVES
FOR YOUR SAFETY READ BEFORE OPERATING
WARNING: If you do not follow these instructions
exactly, a fire or explosion may result causing property
damage, personal injury or loss of life.
A. This appliance is equipped with an ignition device
which automatically lights the pilot. Do not try to
light the pilot by hand.
B. BEFORE OPERATING Smell all around the
appliance area for gas. Be sure to smell next to
the floor because some gas is heavier than air
and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
* Do not try to light any appliance.
* Do not touch any electric switch:
do not use any phone in your building.
* Immediately call your gas supplier from a
neighbor's phone, follow the gas supplier's
instructions.
* If you cannot reach your gas supplier, call
the fire department.
C. Use only your hand to push in or turn the gas
control knob. Never use tools. If the knob will
not push in or turn by hand, do not try to repir it,
call a qualified service technician.
D. Do not use this appliance if any part has been
under water. Immediately call a qualified service
GAS CONTROL KNOB SHOWN IN "OFF" POSITION
GAS CONTROL KNOB
SHOWN IN "OFF" POSITION
GAS INLET
Fig. # 8081
Fig. # 8243.0
Fig.# 8083
THERMOCOUPLE
4