Filter
Top Products
Conversion to LP gas
This conversion must be performed by a competent
person. After conversion the installation must comply
with the relevant regulations and also the local
electricity supply company requirements. Read the
instructions before converting this appliance.
Failure to convert the appliance correctly could
invalidate any warranty or liability claims and lead to
prosecution.
This instruction must be used in conjunction with
the rest of the appliance instruction, in particular
for information on Standards, hotplate positioning,
connection hose suitability etc.
When servicing or replacing gas-carrying components
disconnect from gas before commencing operation and
check appliance is gas sound after completion.
Do not use re-conditioned or unauthorised gas controls.
Before electrical re-connection, check that the appliance
is electrically safe.
Remove burner caps and heads. Remove old jets. Fit the
new jets (see Technical Data section at the back of the
book for correct jets). Reassemble in reverse order.
Disconnect from electricity supply.
Pull off all the control knobs and remove the two
hexagon headed screws (which act as locators for the
pan support), from the edge of the hotplate under the
right hand pan support.
Slide the glass to the rightslightly and lift it from the
side. Carefully lift it clear of the hotplate and place the
panel somewhere safe. The tap bypass screws are now
accessible once the bezel location brackets are removed.
Turn the bypass screw on each control clockwise to the
stop.
Refit the glass panel and replace the fixing screws in the
top edge of the hotplate.
Carefully replace the control sealing rings and replace
the control knobs.