Filter
Top Products
Page 22
250-7251G
August 20, 2009
R
Castile Pellet Insert
1. Open the hinged cast face and open the glass door
assembly.
2.
Positioning the logs.
Place the right rear log as shown. There is a notch in
the bottom of the log for clearance for the thermocou-
ple and thermocouple cover (ceramic protection tube).
Figure 22.1
Continue placing the last 3 logs around the fi repot as
show in Figures 22.2, 22.3 and 22.4. Be careful not to
block the drop tube in the back of the fi rebox where pel-
lets feed into the fi repot.
Four Piece Log Set Installation
Place
the log over the fi repot. The charred
area on the log is turned toward the back, not
the front.
The log will be about 2-1/2 inches (64mm)
above the fi repot when in place. It must rest
on the 3 logs in a stable position to prevent it
from falling into the fi repot. Figure 22.5.
G. Optional Log Set Placement Instructions
Notch
Thermocouple
Cover
Drop Tube
Figure 22.1
CAUTION
Logs are FRAGILE. Use extreme care when handling or
cleaning logs.
NOTE:
Due to the abrasive nature of a pellet appliance fi re, the
logs are not covered under warranty. Any placement varia-
tion other than shown here can cause excessive heat and
shall void the appliance warranty.
Figure 22.2
Figure 22.3
Figure 22.4
Top Log Installation
Figure 22.5