Filter
Top Products
R
August 20, 2009
250-7251G
Page 37
Castile Pellet Insert
Re-installing Baffl e & Brick Set
1. Place right
brick in behind the right bracket, and then
slide to the left so the tabs are behind the center brick.
Figure 37.4
2.
The brick will be fl ush against the back wall and notches
exposed in the side bracket. Figure 37.5.
3. Lift slightly and pull the right edge of the brick forward until
it stops and then drops down into both top and bottom
notches of right bracket and locks into place. Figures
37.1 and 37.2.
4. Repeat for left brick.
5. Insert baffl e into top front inside the fi rebox and pull for-
ward. Then raise up the bottom end and insert baffl e tab
into slot on the top of the right bracket to lock into place.
Figure 37.3. Place the left side hook at the bottom of
the baffl e over the top edge of brick for stability. Figure
37.4.
6. The baffl e does not completely cover the top of the fi re-
box. There is an opening on the left as shown in Figure
37.5.
G. Baffl e & Brick Set Removal
Figure 37.3
Hook on
left side
Tab on
right side
Tabs
Brick is flush against back wall
Notches
exposed
Figure 37.4
Figure 37.5
Remove Right
& Left Brick
Vacuum
Exhaust Area
Right Brick
Removed
Figure 37.1
Figure 37.2
1. Follow proper shutdown procedures on Page 31
.
The top baffl e has a hook on the bottom left side that
rests on the top lip of the cast brick. There is a tab on
the bottom right side that hooks into the side bracket.
Remove the top baffl e by fi rst pulling the baffl e forward
until back edge drops down. Then slide baffl e back until
the front edge clears the shelf that it had been resting on.
Figure 37.1.
3
. The top baffl e must be removed before you can remove
the right and left brick. Remove the right brick by hold-
ing top lip of brick and lifting up, then push outside edge
back. Slide brick to the right until it is fl ush with the fi rebox.
Rotate the inside edge of the brick forward and remove
brick. Repeat for left brick. Figure 37.2.