Filter
Top Products
Part 4
alterations by the system integrator. Besides the standard single key installed,
there are double keys and blank keys for purchase to provide more convenient
user interface.
When replacement of keytop is required, it is advisable to use a
flattop (minus sign) screw driver (Do not use the attached key clip for this
operation.) to help getting the key top off gently. Please always first orientate
the key tops as below before inserting any keytop into the case of the keypad.
Failure to do so could result in permanent damage not covered in product
warranty. Please always match the latching tab on bottom stem of keytop with
the tab in guiding hole and gently press the key top down till a click sound is
heard as indicated in the pictures below.
Labeling On Keytop
The programmable keypad is provided with an easy and durable
method for reminding the user of content programmed in each programmable
key. First preprint (or write) in each cell of the attached colored legend sheet
the “name” for each key. Stick each cell to the corresponding keytop and then
put on the transparent key cap from the accessories. In this way, the labeling
will be protected and resistant to scratch or rubbing.
When re-labeling is required, please use the attached key clip to hook
up the transparent key cap and change the label then re-cap.
KEYPAD PROGRAMMING
The programming of the keys above the numerical keypad in KP-300
/ KP-300T is in general the task of the system integrator and not the average
end user. For end user, please go to the chapter of “OPERATION GUIDE” of
this manual directly.
Utility Installation
In the Posiflex Product Information CD attached with KP-300 / KP-
300T, there is a subfolder named as “\Drivers\KP” or please download from
our web site: http://www.posiflex.com.tw/DriversDownload.asp the keypad
programming utility for KP-300 / KP-300T.
In the above mentioned subfolder please find a further subfolder
“uKBW_xxx” with “xxx” representing any number of the utility revision. This
Single key top
Latching tab
Double key top
Tab in the
guide hole