Filter
Top Products
, Baby unit: (Fig. 3)
- Turn the locking knob with a coin and remove the lid.
- Remove the batteries from the battery compartment, if present.
- Use a small, at screwdriver to turn the channel selector to the desired position.
, Parent unit: (Fig. 4)
- Turn the locking knob a quarter turn (1) and slide the battery cover downwards to remove it
(2).
- Remove the batteries from the battery compartment, if present.
- Use a small, at screwdriver to turn the channel selector to the desired position.
Note: Make sure both units are set to the same channel.
If you do not experience any interference when you test the connection, close the battery
compartments of the baby and the parent units.
If you experience interference, set the selector to another channel and test the connection again.
If the units are operating on non-rechargeable batteries, replace the batteries and close the battery
compartments.
Cleaning and Maintenance
Do not immerse the parent unit or the baby unit in water and do not clean them under the tap.
Do not use cleaning spray or liquid cleaners.
- Unplug the baby unit or the parent unit if they are connected to the mains.
- Clean the parent unit and the baby unit with a damp cloth.
Make sure the units are dry before you connect them to the mains.
- Clean the adapters with a dry cloth.
Storage
When you are not going to use the baby monitor for some time, remove the non-rechargeable
batteries from the baby unit and parent unit. Store the baby unit, the parent unit and the adapters in
a cool and dry place.
Replacement
Baby unit
Batteries
Only replace the non-rechargeable batteries of the baby unit with four 1.5V R6 AA batteries.
Note: We strongly advise you to use Philips non-rechargeable batteries.
Adapter
Only replace the adapter of the baby unit with an adapter of the original type. You can order a new
adapter from your dealer or a Philips service centre:
- SBC CS0920/00W (EU/SGP only)
- SBC CS0920/05W (UK only)
- 9VD200 (AU/NZ only)
Parent unit
Batteries
Only replace the non-rechargeable batteries of the parent unit with four 1.5V R6 AA batteries.
Note: We strongly advise you to use Philips non-rechargeable batteries.
ENGLISH10