Filter
Top Products
8.1 FUNCTION ASSIGNMENT
The display will now show the current setting of the FCP e.g.
Function position - 1 2 3 4 5 6 7 8 9
Display shows - “A I I S I I I xx y” (xx = FCP Nr. ; y = Relay Nr.)
Enter the required status by keying in position Nr. 1 - 7, followed by keystrokes “0” or “1”
Keystroke “0” inhibits the function and the display will indicate “I” in this position
Keystroke “1” enables the function and the display will show function letter i.e. “A” and “S” above
The PROGRAM keystroke will store the new data and scroll to the next program step.
8.2 DELAY ACTION TIME
The display will show the current delay action time of the selected relay e.g. “DEL. xx 01 2”
(xx = the current delay time (FCP Nr.01, relay Nr. 2))
Values between 00 and 99 seconds are valid entries
Enter the new time and scroll to the next program step by pressing the PROGRAM key
8.3 PULSE TIME
The display will show the current “pulse time” of the selected relay e.g. “PT. xx 01 2”
(xx = the current pulse time (FCP Nr.01, relay Nr. 2))
Values between 00 and 99 seconds are valid entries
Pulse time 00 - Will inhibit the pulse action and set the relay, after delay time, to active.
Enter the new time and scroll to the next program step by pressing the PROGRAM key
8.4 STANDBY STATUS
The display will show the current relay standby status e.g. “de-ener 01 2” or “energ 01 2”
(FCP Nr.01, relay Nr. 2))
Keystroke “0” - Will set or leave the status to de-energised
Keystroke “1” - Will set or leave the status to energised
Scroll to the next program step by pressing the PROGRAM key
8.5 ALARM CALL TRANSMISSION
The display will show “ALC enable” or “ALC inhibit”
Keystroke “0” - Will set or leave the status to alarm call transmission inhibit
Keystroke “1” - Will set or leave the status to alarm call transmission enable
Enter the new status and press the PROGRAM key. Pressing the PROGRAM again will scroll to the next relay Nr .
Press the RESET key to return to “PS menu” mode and RESET key again to close the Editor mode.
INSTALLATION INSTRUCTION 69
DP 6000 DIGITAL PAGING SYSTEM
Page 9/15 December 1997