Filter
Top Products
4.3 Address Status Changing within Command “4” (STA FCP NR.) Submenu:
The following gives the correct key selections necessary to move from one status to another:
FROM TO KEY IN FROM TO KEY IN
“Present” “Allocate” 0 - 1 “Unalloc” “Present” 1 - 1
“Present” “Unalloc” 0 - 2 “Unalloc” “Allocate” 1 - 1 - 0 - 1
“Present” “Reply MB” 1 - 3 “Unalloc” “Reply MB” 1 - 1 - 1 - 3
“Allocate” “Present” 1 - 1 “Reply MB” “Present” 0 - 3 - 1 - 1
“Allocate” “Unalloc” 0 - 2 “Reply MB” “Allocate” 0 - 3 - 0 - 1
“Allocate” “Reply MB” 1 - 3 “Reply MB” “Unalloc” 0 - 2
5 MENU - DIRECT CALL KEY Edit Direct Call
This menu is used to program a) Enable/inhibit the call string
b) Edit the direct call address,codinf and info digits
c) Edit the Alarm Call String
d) Edit the PST acknowledge address
e) Enable/inhibit speech after direct call
e) Manual/automatic acknowledge mode
f) Alarm Call repeat time
g) Manual acknowledge time
When editing the following Direct Call data, pressing the PROGRAM key will go to the next program step.
When the display shows “update?” the PROGRAM key must be used to store data .
After PROGRAM key action, the Desk continues with the next channel number.
Pressing RESET during sub menu programming, the display shows “update” .
Pressing RESET whilst desk display shows “PS menu” the desk steps out of the Editor mode.
When the edit Direct Call menu is opened, the display info will differ depending whether one or more FCPs are connected.
1. More than one FCP connected: Display shows “sel.FCP nr “ and the lowest allocated address, of which
the status is “Present”, is displayed.
Scroll the FCP addresses with the PROGRAM key and input the desired address with the DIRECT CALL KEY.
The display will now show “sel. Chan. nr”. Select the channel to be edited (01 - 16) and the display will show the channel Nr. followed by
“DC inhibit” or “DC enable” :
2. One FCP connected: The sequence is as previous paragraph but starts from “sel. Chan. nr.”
displayed.
5.1 ENABLE/INHIBIT THE CALL STRING
Keystroke “0” - Will set or leave the status in inhibit
Keystroke “1” - Will set or leave the status in enable
The display will now show the selected status
Press the PROGRAM key to edit the next step. RESET key to move to “Update?” .
5.2 EDITING THE DIRECT CALL STRING
The display will show “FCP Nr., Channel Nr. , “d” and the call string (e.g. 0105d - - - - - - - - - - ).
The new call string can be entered using the desk hex. key pad (Address - 4 digits / Codinf -1 digit / Info - 5 digits).
This call will be transmitted when the FCP channel DIRECT CALL key is pressed.
Press PROGRAM key to go to next program step. RESET key to move to “Update?”.
INSTALLATION INSTRUCTION 69
DP 6000 DIGITAL PAGING SYSTEM
Page 5/15 December 1997