Filter
Top Products
6 1-800-732-2677
A. Place Batteries in the SmartDoor
™
1. With a Phillips screwdriver, remove the two Battery
Compartment Cover screws.
2. Remove the Battery Compartment Cover.
3. Refer to the inside of the Battery Compartment
Cover for the proper orientation of the four D-Cell
(LR20) batteries.
4. Replace the Battery Compartment Cover and re-
install the two screws.
5. When the batteries are placed in the Electronic
SmartDoor
™
the red light will illuminate for
two seconds and the fl ap will move into the
locked position, unless the fl ap is already in the
locked position.
NOTE:
The door must be in the upright position for
the fl ap to center properly and operate correctly.
B. Place Battery in the SmartKey
™
1. Place the PetSafe
®
RFA-67 battery into the bottom of
the SmartKey
™
.
2. Using a coin, rotate one-quarter turn clockwise to
secure the PetSafe
®
RFA-67 battery.
NOTE:
The SmartKey
™
has a red light that will fl ash
when the PetSafe
®
RFA-67 battery is low; the battery
should be replaced as soon as possible.
C. Check Operational Modes Before Installation
Operational Indicators
Electronic SmartDoor
™
A. Sensitivity Knob
B. Locked or Low
Battery Red Indicator
C. Unlocked or Learn
Mode Green Indicator
D. Automatic or Error
Mode Yellow Indicator
E. Mode-Reset
Selection Button
F. Learn Mode Button
B C D E F
A
• To check if operational settings are working properly, hold down the MODE-RESET button
until each operational mode has cycled through once to allow red, green and yellow lights to
illuminate one at a time.
Operational Modes
LOCKED MODE – Does not allow entry or exit for any pet. The SmartDoor
™
ships from the
factory in LOCKED MODE and when batteries are placed in the SmartDoor
™
, it will enter
LOCKED MODE. To set: hold the MODE-RESET button until red light illuminates and release
when selected.
UNLOCKED MODE – Allows entry and exit for all pets. To set: hold the MODE-RESET button
until the green light illuminates and release when selected.