Filter
Top Products
www.petsafe.net 5
SmartDoor
™
– The SmartDoor
™
is an intelligent receiver using an internal antenna to pick up a
unique SmartKey
™
code for selective pet entry and exit.
SmartDoor
™
Flap – The SmartDoor
™
fl ap is a weather resistant, plastic fl ap with UV
sun protection.
Antenna - The antenna is located inside the SmartDoor
™
and receives radio signals from the
SmartKey
™
. The SmartKey
™
must be located within a certain proximity of the antenna in order for
the unique code to be read.
Radio-frequency Interference – Radio-frequency interference is due to radio-frequency signals
from other household appliances or common electronic products that negatively affect the ability
of the SmartDoor
™
to receive a signal from a SmartKey
™
. Radio-frequency interference or “noise”
can come from a variety of sources. Interference can be minimal, constant or ever changing based
on usage and closeness of other electronic household items during SmartDoor
™
’s operation. It is
recommended that household appliances and common electronic products be placed at least two
feet (60 cm) away from the SmartDoor
™
’s location.
Sensitivity Knob – Conveniently placed on the interior frame of the SmartDoor
™
is the sensitivity
knob. You can easily adjust the SmartDoor
™
’s sensitivity, taking into account common interferences
and environmental factors to optimize SmartDoor
™
operation.
Sensitivity Level – The level of sensitivity can be adjusted by turning the sensitivity knob
from minimum to maximum, depending on radio-frequency interference and the SmartDoor
™
’s
application and/or location. Pre-set from the factory, the sensitivity level should not be adjusted
until after installation. For example, the sensitivity level may need to be increased if the
SmartDoor
™
is installed in a metal door. Reference page 10 for more information on how to
adjust sensitivity.
MODE-RESET Button – Easily select an Operational Mode on your SmartDoor
™
by holding the
MODE-RESET button to cycle through selections of operation: LOCKED, UNLOCKED or AUTOMATIC.
LEARN Button – The LEARN button programs a SmartKey
™
’s unique code to be read by the
SmartDoor
™
. (One) SmartKey
™
comes programmed and ready to use. You may program up to fi ve
SmartKeys
™
(each sold separately) to one SmartDoor
™
.
Operational Modes
LOCKED Mode – The SmartDoor
™
fl ap is locked and does not allow entry or exit for any pet.
UNLOCKED Mode – The SmartDoor
™
fl ap is unlocked and allows entry and exit for all pets.
AUTOMATIC Mode – The SmartDoor
™
fl ap is electronically locked and allows entry and exit for
the pet wearing a programmed SmartKey
™
.
Battery Compartment – The battery compartment is located on the Interior Frame and requires
(four) D-cell (LR20) batteries. Installation mounting screws, key ring, SmartKey
™
and the (one)
RFA-67 battery are all located inside the battery box during shipping for your convenience.
RFA-67 Battery – The RFA-67 battery powers the SmartKey
™
and is replaceable. Additional
RFA-67 batteries are available at retailers, or by calling PetSafe
®
Customer Care Center or visiting
www.petsafe.net. Typical life of the RFA-67 is approximately six months.
Outer Frame Size – Overall pet door dimensions
Cut-out Size – Opening cut in homeowner’s door for proper fi t and pet door installation
Replacement Flap Size – Overall fl ap size when removed from pet door
Flap Opening Size – Usable fl ap space for pet to enter and exit through the pet door
Interior Frame – Pet door frame on the inside of home
Exterior Frame – Pet door frame on the outside of home
PREPARE
Preparing Your SmartDoor
™
DO NOT PROCEED WITH CUT-OUT OR INSTALLATION UNTIL ALL STEPS A-D BELOW
HAVE BEEN COMPLETED. DO NOT REMOVE SENSITIVITY STICKER UNTIL AFTER
INSTALLATION.