Filter
Top Products
www.petsafe.net 11
C. Programming a New SmartKey
™
To reduce error while programming, remove the RFA-67 battery from all programmed SmartKeys
™
except the one you are programming. Press and hold the LEARN button until the green light
illuminates and begins to fl ash, now release the button. Bring the SmartKey
™
directly below the
green light and the light will stop fl ashing and illuminate for two seconds. Now your new SmartKey
™
has been programmed and added to memory. Up to fi ve different SmartKeys
™
can be added, one at
a time.
D. Attach the SmartKey
™
to the Pet’s Collar
A split key ring has been provided to attach to your pet’s
collar and should hang under the pet’s neck.
The SmartDoor
™
includes (one) SmartKey
™
which comes
pre-programmed and ready to use.
OPERATE
Operating Your SmartDoor
™
LOCKED MODE – Does not allow entry or exit for any pet. The SmartDoor
™
ships from the factory
in LOCKED MODE and when batteries are placed in the SmartDoor
™
, it will enter LOCKED MODE. To
set: hold the MODE-RESET button until the red light illuminates and release when selected.
UNLOCKED MODE – Allows entry and exit for all pets. To set: hold the MODE-RESET button until
the green light illuminates and release when selected.
AUTOMATIC MODE – Allows entry and exit for a pet wearing a programmed SmartKey
™
; up
to fi ve SmartKeys
™
can be programmed into one SmartDoor
™
for selective entry and exit during
automatic mode. To set: hold the MODE-RESET button until the yellow light illuminates and
release when selected.
NOTE:
If at any time the red light remains illuminated, replace with a set of fresh batteries. If that
does not reset the red light, please call our Customer Care Center for additional help.
Illuminating Color Condition Pet Door Status
RED
Solid only for two seconds after
selecting LOCKED Mode
LOCKED Mode
Flashing Low battery alert
Constant solid Internal failure has occurred
GREEN
Solid only for two seconds after
selecting UNLOCKED Mode
UNLOCKED Mode
Flashing Learn Mode
YELLOW
Solid only for two seconds after
selecting AUTOMATIC Mode
AUTOMATIC Mode
Flashing Error alert
RED, GREEN AND YELLOW
Flashing at the same time Sensitivity Test Mode
Troubleshooting
SmartDoor
™
does
not respond to the
presence of the
SmartKey
™
when my
pet is directly in front
of the SmartDoor
™
within three seconds
• Check that the SmartDoor
™
is in AUTOMATIC Mode.
• Check that the SmartKey
™
has been programmed to the SmartDoor
™
.
• Check sensitivity level has been properly set, see page 10.
• Check that the RFA-67 battery in the SmartKey
™
is screwed in tightly.
• Check that the batteries in the SmartDoor
™
are fresh.
• If the condition persists, check that there are no radio-frequency
transmitting devices or electronic devices that radiate electrical
energy, which may interfere with the operation of the SmartDoor
™
.