Filter
Top Products
www.petsafe.net 17
Prepare the Receiver Collar
To Insert and
Remove the Battery
Note: Do not install the battery while the
Receiver Collar is on your pet.
This Receiver Collar utilizes a
replaceable PetSafe
®
battery
(RFA-188). This unique battery is
designed to make battery replacement
easier and increase water protection.
To activate the collar, insert the battery
module (5A). Using the edge of the
Test Light Tool as shown, turn the
battery clockwise until the vertical line
on the battery is pointed to the “ON”
position (5B). If the PetSafe
®
Receiver
Collar is not going to be used on
the pet immediately, leave it in the
“OFF” position.
5A 5B
5D
5C
To remove the battery, turn the battery counter-clockwise using the edge of the
Test Light Tool as shown (5C, 5D). DO NOT attempt to cut into or pry open
the battery. Be sure to discard the used battery properly.
A replacement PetSafe
®
battery can be found at many retailers. Contact the
Customer Care Center or visit our website at www.petsafe.net to locate a retailer
near you.
Static Correction and Battery Test Feature
When the RFA-188 Battery Module is fi rst installed in the Receiver, the red LED
will fl ash the current correction level setting (1-5). For the next 30 seconds, the
receiver will monitor the battery status and will either fl ash the green LED once
every 5 seconds to indicate a good battery, or fl ash the red LED once every 5
seconds to indicate a low battery condition.
After the 30 second battery test period, the green LED will cease to fl ash if the
battery is good. If the battery was low during the test period, the red LED will
continue to fl ash at a rate of 1 fl ash every 20 seconds to indicate a low battery
condition. In this situation, battery replacement is recommended.
To Set the Static Correction Level
Read all steps before attempting to set the Static
Correction Level.
With the battery installed, press the Correction Level 1.
Button and release when the Receiver Indicator Light
illuminates red (5E).
The Receiver Indicator Light will emit a number of 2. red
fl ashes representing the Static Correction Level (5F).
Increase the Static Correction Level by pressing and 3.
releasing the Correction Level Button within 5 seconds
of the previous fl ashes.
5E
5F
Step
5