Filter
Top Products
www.petsafe.net 7
To Turn the Receiver Collar On:
1. Press and hold the On/Off Button until the Receiver Indicator Light comes on and
the Receiver Collar beeps 5 times.
2. Release the On/Off Button.
Once the Receiver Collar has been turned on, press the Side Button of the Remote
Transmitter. The Receiver Collar should beep for as long as the Side Button is pressed.
If it does not, see the “Reset the Receiver Collar” section.
The Receiver Indicator Light will fl ash once every 4 to 5 seconds if the batteries are low.
To Turn the Receiver Collar Off:
1. Press and hold the On/Off Button until the Receiver Indicator Light comes on and
the Receiver Collar beeps 2 times.
2. Release the On/Off Button.
Note: To extend the life of the batteries, turn the Receiver Collar off when it is not in use.
Important: If the Receiver Collar is left on continuously, the maximum battery
life (before replacing batteries) will be two weeks.
_____________________________________________________________
Fit the Receiver Collar
Important: The proper fi t and placement of your Receiver Collar is important
for effective training. The Contact Points must have direct contact with your
pet’s skin on the underside of his neck.
To assure a proper fi t, please follow these steps:
1. Have your pet standing comfortably (3A).
2. Centre the Contact Points underneath your pet’s neck, touching
the skin (3B). If your pet has a long or thick coat, use the enclosed
long Contact Points to reach through the hair. Note: It is sometimes
necessary to trim the hair around the Contact Points to make sure that
contact is consistent.
3A
3. The Receiver Collar should fi t snugly, yet
loose enough to allow one fi nger to fi t
between the collar and your pet’s neck (3C).
4. Allow your pet to wear the collar for several
minutes then recheck the fi t. Check the fi t
again as your pet becomes more comfortable
with the Receiver Collar. If your pet’s neck is
less than 300 mm around, you will need to
thread the part of the collar which includes
the antenna through the buckle. It will be a
tight fi t.
5. Trim the collar as follows (3D):
a. Mark the desired length of the collar with a
pen. Allow for growth if your pet is young
or grows a thick winter coat.
3B
3C
Step
3