Filter
Top Products
6 INTERIOR SEAL
Caution: Ensure use of low pressure polyurethane window and door insulating foams
and strictly follow the foam manufacturer’s recommendations for application. Use of high
pressure foams or improper application of the foam may cause the door frame to bow and
hinder operation.
5 REINSTALL THE SLIDING PANEL
TWO OR MORE PEOPLE WILL BE REQUIRED FOR THE FOLLOWING STEPS.
A. Insert door panel. From the exterior of the building, tilt the top
of the panel toward the door frame and insert the top of the door
panel into the top track. Move the bottom of the panel toward the
door frame until it is vertical. Gently set the panel down into the
bottom track.
ProLine only: Install bumpers and the panel retainer. Follow the
instructions included in the hardware box.
Note: Be careful not to pinch your ngers between the two panels. DO NOT close the sliding
panel until you have installed the hardware. e door may lock when closed.
5A
Interior
6A
Exterior
4D
4C
C. Fold down top ap of water resistive barrier (4C).
D. Apply ashing tape to diagonal cuts. Cut pieces of ashing
tape at least 1" longer than the diagonal cuts in the water resistive
barrier. Apply the tape covering the entire diagonal cut in the water
resistive barrier at both upper corners of the door.
Note: Be sure to overlap the top corners (4D).
B. Install the handles and panel retainer. Follow the instructions included in the hardware
box. If the panel is not square to the door frame, adjust the bottom rollers by removing the
adjusting hole cover and inserting an 8" long #2 Phillips screwdriver into the hole. Turn
clockwise to raise the panel and counter-clockwise to lower the panel. Follow the instructions
included in the handle box for nal adjustments.
C. Install screen. Instructions for installing the screen are found in the screen door package.
A. Apply insulating foam sealant. From the interior, insert the
nozzle of the applicator approximately 1" deep into the space
between the door and the rough opening and apply a 1" deep
bead of foam. If using foam other than Great Stu
™
Window
and Door Insulating Foam Sealant by the Dow Chemical
Company, allow the foam to cure completely (usually 8 to 24
hours) before proceeding to the next step.
Note: DO NOT completely ll the space from the back of the
n to the interior face of the opening.
B. Check the door operation by opening and closing the door.
Note: If the door does not operate correctly, check to make sure it is still plumb, level, square
and that the sides are not bowed. If adjustments are required, remove the foam with a
serrated knife. Adjust the shims, and reapply the insulating foam sealant.