Filter
Top Products
10 C2941M-C (6/08)
Installation
LENS MOUNTING
The camera can be used with a fixed iris, manual iris, or auto iris lens. The camera is factory set for a
CS mount lens, but is easily adjusted for a C mount lens.
1. C mount lens only: Completely rotate the back focus adjustment counterclockwise before
installing the C mount lens (refer to Back Focus Adjustment on page 15).
2. Set the lens mode selector switch on the side of the camera to AIV (auto iris video drive) lens or AID
(auto iris DC drive) lens. Refer to Switch Settings on page 16. Switch settings are determined by the
type of lens used.
3. Screw the lens onto the lens mount. Be careful to prevent dust from entering the space between the
lens and the CCD element. If necessary, use clean compressed air to remove any foreign matter.
4. Connect the auto iris lens to the 4-pin connector located on the side of the camera. Pin connections
for the iris drive connector are as follows:
CAMERA MOUNTING
Use a standard 1/4-20 screw (provided) with a maximum thread length of 3/8-inch (10 mm) for mounting to
the top or bottom of the camera.
PIN DC (AID) AUTO IRIS LENS VIDEO (AIV) AUTO IRIS LENS
1 Control coil negative (-) Lens positive supply
2 Control coil positive (+) Not used
3 Drive coil positive (+) Video drive signal
4 Drive coil negative (-) Ground
3 4
12