Filter
Top Products
[ 6 ] Pelco Manual C2436M-B (9/02)
3 Connect Video and Power
1. Connect the video cable. Place the cable inside the MR5000 Series mount arm and install the
bottom end cap of the mount to conceal the cable.
2. Depending on the input voltage, connect either the 12 VDC or 24 VAC input power wires to
the appropriate positions on the terminal block inside the base.
3.
12 VDC Operation Only –
The camera is set for 24 VAC operation at the factory. For 12 VDC operation remove the jumper
from the 24 VAC position and install it on the 12 VDC position.
2 Prepare Video and Electrical Cabling
1. Temporarily remove the bottom end cap of
the MR5000 Series mount if it is installed.
2. Feed the 42-inch video cable (provided)
through the monitor feedthrough hole in the
mount arm and out the bottom end of the
mount arm.
3. Pull power wires through the ICS-DO101ABK
feedthrough located at the bottom of the
mount arm. Remove the .50-inch plug
if it is installed.
4. Pull wires through the adapter plate of the
ICS-DO101ABK and into the base of the
ICS-DO101ABK.
5. Use the supplied 3/16-inch Allen wrench and slightly loosen
(do not remove)
the two
5/16-18 x .75-inch Allen pan head screws that secure the MR5000M mount base to the mount arm.
6. Feed the video cable attached to the ICS-DO101ABK back box through the ICS-DO101ABK
feedthrough in the mount arm and out the bottom end of the mount arm.
7. Hook the adapter plate over the loosened screws. Tighten the screws to secure the adapter plate
to the mount.