Filter
Top Products
C2491M-C (1/06) 9
3. Using a blunt tool push out the wiring plug in the bottom of the base (refer to Figure 6).
Pull the wiring inside the base.
Figure 6.
Removing the Wiring Plug
4. Insert the hole plug that is supplied into the hole in the base of the Camclosure (refer to
Figure 7).
Figure 7.
Installing the Hole Plug
5. Remove the conduit cover from the end of the base by loosening the inset screw located
on the bottom of the base and then using a screwdriver to remove the conduit cover.
HOLE PLUG