Filter
Top Products
4 Pelco Manual C495M-D (12/96)
Figure 1. HB6000, HB6000/220, HB6024 Assembly
4.3.2 Heater/Blower Kit Installation
To install the HB6000, HB6000/220, HB6024, perform
the following steps (refer to Figure 1).
4.3.2.1 Heater Assembly
1. Open an access door (both if needed).
2. The heater bracket is designed to attach to two (2)
adjacent studs retaining the window.
3. Remove any two (2) adjacent nuts and washers on
both sides of the window.
4. Place the heater brackets on the studs, heaters
angled away from the window, and replace and
tighten the hardware.
4.3.2.2 Blower/PCB Assembly
1. Open an access door (both if needed).
2. On the HS6000, the blower/PCB bracket is de-
signed to attach to the two (2) studs at the bottom
of the window.
3. Remove the nuts and washers retaining the bottom
of the window.
4. Place the blower/PCB bracket over the studs and
replace and tighten the hardware.