Filter
Top Products
Important:
Each press of a button
is confirmed (as
received) by the
reader/receiver by a
single beep. Press the
TELPRO
™
buttons
gently.
Programming using TELPRO
™
as a remote
wire-free programmer.
Remote Programming Range:
Infra-Red Receiver 20 cms - 5 metres
Proximity Reader 5 cms - 10 cms
How to use the TELPRO:
Flick TELPRO switch to ON - Red LED on the right must light up.
(Remember to turn unit off when finished)
Point TELPRO at the reader/receiver.
Enter the Master Code and wait for the reader/receiver to start beeping every 4 seconds
OR
Flick Programming Switch SW1 and wait for the reader/receiver to start beeping every 4 seconds
(Remember to turn off the programming switch SW1 when you have finished programming).
Follow programming instructions
Note: An incorrect programming operation is signalled by a series of 3 beeps.
8
Programming using TELPRO
™
as a
hard-wired programmer
How to use the TELPRO as a hard wired unit:
Insert the jack connection into the top of the TELPRO unit.
Plug the connector terminal onto J5 on ECP Door Controller.
Enter the Master Code and wait for the unit
to start beeping every 4 seconds
OR
Flick Programming Switch SW1 and wait for the unit
to start beeping every 4 seconds
(Remember to turn off the programming switch SW1
when you have finished programming)
Follow programming instructions.
Dimensions (mm):
120L x 60W x 25D
J5 = Access Point 1
J6 = Access Point 2
ECP290/ECP200
Important:
Each press of a button is confirmed (as
received) by the Door Controller by a
single beep.
Press the TELPRO
™
buttons gently.